Safety Loop Detector Closing Loop For Vehicle Sensing Applications

Safety Loop Detector Closing Loop Barrier Gate

JTLD-105 is a single channel loop detector designed for vehicle access parking driveway gate applications, gate Exit loops are used to open gates to allow a vehicle's exit;  gate Safety loops are used to prevent a gate from closing on a vehicle. JUTAI was built much experience in the parking and access control industries. Our single-channel loop detectors provide you a high functionality experience.

Safety Loop Detector Closing Loop installation

Safety Loop Detector Closing Loop Specifications

• Self-turning range: 20-2000μH
• Sensitivity : 16 way selectable /Highest 0.010% DL/L / Lowest 2.56% DL/L
• Frequency: Four steps switch selectable 20-80KHz
• Power Requirements : 110-240VAC (48 to 62Hz)  /   12-24VADC(48 to 62Hz)
• Operation Temp : -40℃ to +70℃ / (-111℉ to +158℉)
• Fault Output: Blinks slowly: It may be because the loop is a short circuit or the number of turns is not enough; Blinks faster: It maybe because the loop is open or the No. of turns is too many.
• Response Times : Turn-on 10-90MS / Turn-off 10-90MS
• Visual Indications: Power LED-Red / Channel LED-Green
• Reset: Reset by a push button on the front of the enclosure
• Relay Output: Presence Relay/Fault Relay output
• Humidity: Up to 95% relative humidity without condensation
• Loop wire: more than 10meters requires the use of a 2 core shield cable, do not exceed 30 meters distance between control box and loop
• Size:75mm*43mm*110mm
• Weight: 190g

Two separate output relays

1. Presence Relay A is presence output. Can be extended for 0,2,5,8,10,15,20 or 30 seconds, programmable with external 10 way DIP switches.
2. Pulse Relay B programmable with external 10 way DIP switches, provides presence, pulse on entry, pulse on exit, or failed output.

Main features

• Single or Dual Loop Detector
• Automatic adjustment of detection level
• Pulse or presence relay output
• LED indication for power, relay status, loop fault

Applications

Jutai Universal-Voltage loop detectors are used wherever vehicles have to be detected. Like monitoring and safe guarding access ways to counting vehicles. The output signal can be used for controlling door and gate drive mechanisms, operating barriers, controlling traffic light systems in car parks or activating card dispensers in car parks

Safety Loop Detector Closing Loop Ordering Information

LD-100  single channel, boxed, 1 type 11pin connects 100-240VAC(EU standard)

LD-102  single channel, boxed, 1 type 11pin connects 12-24VADC(EU standard)

LD-105  single channel, boxed, 2 type 11pin connects 100-240VAC(USA standard)

LD-106  single channel, boxed, 2 type 11pin connects 12-24VADC(USA standard)

Ordering Other Related Products

• High-Quality Loop Cable 305m/roll
• Photocell Beam Sensors 1-20m
• LED Traffic Light 100mm 110-240V or 12-24V
• Automatic Barrier Boom Gate 1-6m
• RFID Long Range Card Reader and card access system
• Car Park Card Dispenser Loop Detector System
• Loop Detector Vehicle Counting System